ASTM E1646 PDF

May 21, 2020 0 Comments

ASTM International E Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure Difference. ASTM E(). Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure. ASTM E is the standard test method for water penetration of exterior metal roof panels by uniform static air pressure difference. The ASTM E test.

Author: Samulabar Faulrajas
Country: Cameroon
Language: English (Spanish)
Genre: Literature
Published (Last): 12 December 2006
Pages: 90
PDF File Size: 7.99 Mb
ePub File Size: 17.24 Mb
ISBN: 160-4-68953-344-7
Downloads: 72299
Price: Free* [*Free Regsitration Required]
Uploader: Vudogor

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

ASTM E1646

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

A section of calibrated spray racks are set in place 12 inches above the specimen.

Historical Version s – view previous versions of standard. After applying the preload there is a two minute recovery period.

A roof contains many details. The test is conducted by attaching the chamber to the test specimen. Then the specimen is preloaded with a negative static air pressure differential for a minimum of 10 seconds. Link to Active This link will always route to the current Active version of the standard. The slope of the roof is significant.

  INTOXICACION POR TIOCIANATOS PDF

This process is repeated for a total asrm three cycles.

In applying the results of tests by this method, note that the performance of a roof or its components, or both, may be a function of proper installation and adjustment. Pre-loading is a essential part of the testing procedure. For specific hazard statements, see 7. The calibrated spray racks shall deliver water uniformly against the roof surface at a minimum rate 1e646 five gallons per square foot per hour.

Read more about what our customers have to say This is e16466 test procedure. Although prescribed modifications are outside the scope of this test method, an experienced testing engineer is able to use the principles presented in this test method and generate significant data by isolating specific details and measuring leakage. This test method shall not, by itself, be relied upon to form conclusions about overall water penetration through metal roofs.

This test method is a specialized adaption of Test Method E The positive test pressure shall be greater than or equal to 15 pounds per square foot.

ASTM E – Farabaugh Engineering and Testing

Practical considerations suggest that every combination of panel thickness, span, and design load need not be tested in order to substantiate product performance.

Some designs are more sensitive than others to this upward moving water. The purpose of this test method is to conduct quality assurance water penetration testing of the roof including panel side laps and structural connections. These factors shall be fully considered prior to specifying the test pressure difference. For that reason the slope of the roof plays a significant importance. The preload test pressure differences positive and negative are to be specified.

  JTAC MOA PDF

Prior to testing a positive static r1646 pressure differential preload is applied.

In service, the performance e146 depends on the rigidity of supporting construction, roof slope, and on the resistance of components to deterioration by various causes: These notes and footnotes shall not be considered as requirements of the test method. It does not include leakage at openings or perimeter or any other details.

SITC has utilized this test method to assist our clients with their quality assurance testing of metal panel roof systems. It is difficult to simulate the identical complex wetting conditions that can be encountered in service, including large wind-blown asym drops, increasing water drop impact pressures with increasing wind velocity, and lateral or upward moving air and water.

Composite systems in which the source cannot be readily determined are outside the scope of this test method. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.